Corrosive Materials (eg. Sb) Valved Cracker Sources
VCOR SERIES
Designed for corrosive material evaporation: Sb, Mg, Te, Se, etc.
-
Highly reproducible flux control -
Performance, flexibiliy and reliability
-
Full reservoir loading capacity from 110cc to 300cc -
Very simple charge refilling -
No delicate valve parts to dismantle -
Only 2 heating zones sources

Characteristics
characteristics | S40 VCOR 110 | S63 VCOR 300 |
---|---|---|
Filament | Two | |
Heating filaments | Ta Wire | |
Thermocouple | Double C-type | |
Crucible / valve material | PBN / PBN | |
Usefull capacity (Max load dimensions) | 110cc (Ø20xH350mm) | 300cc (Ø31xH500mm) |
Mounting flange (min) | CF 40 (2.75") | CF 63 (4.5") |
Reservoir typical operating temperature | 450°C-500°C | |
Tip typical temperature | 650°C-900°C | |
Temperature stability | +/-0.3°C | +/- 0.1°C |
Valve characteristics | ||
Open conductance | 2.0 l/s | 10.0 l/s |
Open / Close ratio | > 1000 | > 1000 |
Valve actuator | Micrometer | |
Stem stroke | 2 mm (4 turns) | 2.5 mm (5 turns) |
Cracker Characteristics | ||
Max outgassing temperature | 1000°C | 1000°C |
Power consumption (cracker @ 1000°C) | 200W | 300W |
Power supply recommended | 7.5A-100V | 7.5A-100V |
Power output connector | Uniplug male Ø5 | |
Thermocouple connector | Omega NMP C-type | |
Reservoir Characteristics | ||
Loading port | CF63 | CF100 |
Max outgassing temperature | 750°C | 750°C |
Power consumption (Res @ 750°C) | 400W | 500W |
Power supply recommended | 7.5A-100V | 7.5A-100V |
Power output connector | Uniplug male Ø5 | |
Thermocouple connector | Omega NMP C-type | |
Water connection | SWG fitting Ø6 female | |
Water flow | 0.3l/mn - 4Bar max |